
w i r e l e s s
s o l u t i o n
Specifications
DMX interface
• Full compliance with USITT DMX-512 (1990) & 512-A standards
• Maximum number of transceivers on a single bus: 32
(compliant with the EIA/TIA RS-485 standard)
• Data Rate: 250 kbps (slew rate limited to minimise EMI)
• Electrostatic discharge protection: ±15kV
• DMX frame rate and frame size: Auto sensing
• Frame rate: 1 (min) to 44 (max) frames per second
• Frame size: 1 (min) to 512 (max) channels
• Loss of DMX input or radio link: After one second (if there is no
resumption), the DMX output will cease to transmit and go into
a high impedance mode.
• Recovery from loss of DMX input or radio link: Less than 1 second.
Power characteristics
• High voltage input: 90-260VAC
• Low voltage input: 12VDC
• Low voltage output: 12VDC @ 300mA maximum
• Average current (receive mode): 200mA @ 12VDC
• Average current (transmit mode): 450mA @ 12VDC
RF characteristics
W-DMX
TM
uses Adaptive Frequency Hopping Spread Spectrum
(AFHSS) and changes frequency every 910uS
• Operational frequency range: 2402-2479MHz (ISM band)
• EU/ASIA RF output power: 20dBm or 100mW
• FCC RF output power: 25dBm or 275mW
• Channel bandwidth: 1 MHz
• Sensitivity at 0.1% Packet Error Rate: 95dBm
• Tested link range 450m (Low power EU mode using standard
antennae in an urban area)
Approvals
•
FCC: 15.247&68 Class B; Canada ICES 003; Japan ARIB STD-T66
• CE;
EN 301 489-1; 301 489-17; EN 300-328-1; EN 300-328-2; EN 609 50
Enclosure
• Injection moulded plastic casing, environmental rating: IP65
• Operating temperature range: -30
o
C to +55
o
C (-22
o
F to 131
o
F)
• Dimensions (W x H x D): 190 x 130 x 45mm (7.5” x 5.1” x 1.8”)
• Weight: 750g / 26.45oz
Connectors
• AC input: 3-pole 5mm terminal via cable gland (Ø4-8mm)
• DC in/out: 3-pole 5mm terminal via cable gland (Ø4-8mm)
• DMX in/out: 3-pole 3.5mm terminal via cable gland (Ø4-8mm)
• W-DMX bus: 5-pole 3.5mm terminal via cable gland (Ø4-8mm)
• External MMI interface: 3-pole 3.5mm terminal
• N-type female radio antenna connector
Supplied accessories
• AC power cord / DC power connector / Standard antenna
Antenna adaptor / Mounting brackets / User guide
Part codes S-1 S-2 R-512 RP-512
ETSI/FCC approved A40002 A40004 A40103 A40201
(power output:
100mW/300mW max.)
Japan ARIB approved A40002J A40004J A40103J A40201J
(power output:
100mW max.)
Phone: +46 522 511 511
Fax: +46 522 440 885
Web: www.wirelessdmx.com
Wireless Solution Sweden AB
Stureparksvägen 7
451 55 Uddevalla
Sweden
Control panel details
Release 1-0d (October 2007) Specifications subject to change without notice
RADIO
ON: Indicates that Level display
is showing signal strength
BATT
ON: Indicates that Level display
is showing battery charge
FUNCTION
Operation depends
upon current
operation mode:
transmit or
receive.
Level Provides alternate
indications of radio signal
strength and battery charge every
two seconds.
DATA
ON: Transmitting/
receiving DMX data
TX/RX
Indicate current
operation mode
CTRL
ON: Indicates that W-DMX
bus link is active
POWER
OFF: Off or using battery
ON: External power input
FLASH: Charging battery
LINK
ON: Normal operation
FLASH: Unlinking all receivers
RAPID FLASH: Linking with receivers
OFF: Not linked to a transmitter
ON: Linked to a transmitter
RAPID FLASH: Linking to a transmitter
TX MODERX MODE
RP-512 Outdoor
W-DMX
made in sweden
Level
Radio
Batt
Wireless Solution
Sweden AB
FUNCTION
POWERDATA
RXTX
CTRLLINK
FUNCTION
Press and release to search for and
link with receivers (for each universe)
DATA (for each universe)
ON: Transmitting DMX data
CTRL (for each universe)
ON: Indicates that W-DMX bus link is active
LINK (for each universe)
ON: Normal operation
FLASH: Unlinking all receivers
RAPID FLASH: Linking with receivers
S-2 Outdoor
W-DMX
made in sweden
Universe 1 Universe 2
FUNCTION FUNCTION
Wireless Solution
Sweden AB
LINK LINK
DATA DATA
CTRL CTRL
RADIO
ON: Indicates that Level display
is showing signal strength
BATT Not used
FUNCTION
Press and release to
search for and link
with receivers
Level Provides
indication of radio input or
output signal strength
DATA
ON: Transmitting DMX data
CTRL Not used
POWER
ON: Correct
power input
present
S-1 and R-512 Outdoor
W-DMX
made in sweden
Level
Radio
Batt
Wireless Solution
Sweden AB
FUNCTION
POWERDATA
RXTX
CTRLLINK
LINK
ON: Normal operation
FLASH: Unlinking all receivers
RAPID FLASH: Linking with receivers
OFF: Not linked to a transmitter
ON: Linked to a transmitter
RAPID FLASH: Linking to a transmitter
S-1R-512
Comentarios a estos manuales